Accident On 380 Princeton Tx Today, Valhalla Funeral Home Belleville, Il Obituaries, Harvard University Id Number, Articles I

Mine does not droop, so a call to tech support may be in order. Clearly I should have gotten the larger unit. The TS-LS is already perfect in measuring increments of 1/32 or 1mm, but when you need to match existing project parts, the large micro-adjust knob turns the lead screw against the mating threads, allowing the fence to move between 1/32 steps with 0.001" (0.025mm) resolution. The recommended mounting of the main rails in the Incra manual will give the user 32 inches to the right of the blade and 16 inches to the left of the blade. The XL version fits most of the newer 10 & 12 cabinet saws with deeper tops measuring 33.5 or less using a longer fence and base support panel. Open Box. I honestly dont know Dan. Can anyone please tell me if any one of these will work with the ibox? but as long as you zero the fence to the blade each time after you move the base clamp your going to be dead on the reading it gives you. Thanks for the heads up Marc, hey while we are on the subject, do have a recommendation for a good/acurate/affordable miter gauge for my PM 64A??? surface to allow movement There is a lot of flexibility with the Incra system to get a rip capacity that meets the needs of the user. I am a stickler for following the set-up instructions on any new tool and this tool was no exception. Create your account and enjoy a new shopping experience. Even if we assume the fence alignment was a defective part or a defective user, I found that the system was a bit cumbersome in-use. Two capacities available: The 32" (810mm) -capacity TS-LS is based on 72" main rails, the 52" (1320mm) -capacity on this page system uses 92 rails, and both systems use the same 32" -travel LS Positioner. Call Us Today! I didn. If you have a left-tilt saw and do not need to use the fence on the left side of the blade, then the main rails can be mounted further to the right. Crap. with any 10" table saw, with no drilling, no tapping and no modifications. If I need to cut wider, I turn to my Festool track saw. Choose from 1/32 imperial or 1mm metric positioning mechanics. The fence is pricey but just think 1/32 and anywhere in between theres not a fence iv see that does that.