Mr Cooper Equity Loan Rates, Savage Axis Ii Precision Sling, Libby Funeral Home Obituaries, What Is Hennepin Dept Of Community Corrections?, Carlos Gaytan Wife, Articles S

This does not apply to the Mint. This is the MOST IMPORTANT step otherwise the Blade Housing Reset will NOT fix cut issues. This is a possible issue with the Cameo. With your hand move the tool carriage all the way to the right and then back to the left. How to use the Silhouette Studio Drawing tools: Lesson 3 Draw an Arc, Draw something! Youre expecting it to do this: But instead of flipping the US only, it flips the entire page like this: The software doesnt show you an indication of that on the screen so you have to know it. Heres the tricky part folks accidentally change that black dot to a different option without realizing it or knowing how to change it back. For more information on cancelling cut jobs, see this post. all of the sudden, i feel like i'm not sure how i lived without the ability to cut all.the.things.. though i had about a day's long learning curve to get through, the machine and program that . Thanks for leaving a comment! Problem:Lets say you have good lighting and your blade is calibrated but your cuts are still not cutting right. If you are having print and cut issues, I would suggest following the steps below and then try a test print following the steps in this postLets Explore v4 Print and Cut BasicsFollowing these steps exactly will eliminate a lot of the possible reasons that print and cut is not cutting accurately. The blade housing should be lined up directly behind the right roller, which is located underneath the roller bar directly where the dot is on the front of the bar.When using a cutting mat, the right roller should ALWAYS be on the edge of the cutting mat and not rolling across the adhesive or material on the mat.The rollers are located underneath the roller bar and there is no easy way to access the rollers for cleaning. If youve got this set wrong, the machine will begin cutting too far down or too far up. After I moved the rollers away from touching my sticker paper, I did not have any more issues. There are several reasons why this happens. Your email address will not be published. You do this by raising and lowering the lever on the right hand side of the machine above the bar. This Silhouette CAMEO calibration tutorial will fix that issue applies to the CAMEO 4 and other older machines.