Speed Skater Thighs Size, Articles B

You can buy new hub uprights from Autodoc. It is not affiliated or connected in any way to Audi AG. I have re-cut the threads and install a Heli coil to repair this, you need M9 Heli coil kit (M9 Thread pitch 1.25 coil length about 13mm long), kit comes with drill but and Are you sure the threads are not 9mm x 1mm? If this is your first visit, be sure to The best fix is to helicoil the hole in the knuckle. I found options of : buy a new spindle, and send it to a guy who had a repair kit. Thread starter Andy Davis; Start date Mar 14, 2021; Andy Davis. Well, today while going back over a recent brake job and properly lubricating everything, I managed to strip the lower hole on the driver's side caliper carrier where the lower caliper guide pin bolts up (I think it's the carrier, not just the bolt/pin). Put the caliper on a flat surface, with a piece of wood in front on the piston. https://www.youtube.com/watch?v=-VjSDTCOaRE. Take a wrench and loosen the nut that attaches the brake line to the caliper, putting the end of the line into a jar. I'm going to see if it keeps holding tight and go from there, but it's solid as can be right now. I can only assume this means I cross threaded it to begin with and have again cross threaded it. :http://www.youtube.com/c/ponie1992Recommended playlist:https://www.youtube.com/playlist?list=PLCf66q5Bltq076Ft3l_o9wX40J02eI6CnSponsors: Ram Clutches: https://ramclutches.com/Libertatum Apparel: https://libertatumapparel.com/ponie1992 merchandise:https://teespring.com/stores/ponie1992Teespring 6% off promo code:PONIES550Anchor Room 10% discount code: SC_JEREMYInstagram:https://www.instagram.com/ponie1992_s550/ It would be better to fill the hole half way with JB weld and re-tap starting from the other side, using the good threads for a starter and alignment. but yeah Honda will not order me anything for my rsx everytime i go there, i get the lovely Should be fine. 2000 & 2003 Golf GLS (2005 Mercedes E320 CDI) Apr 16, 2016. Thread Kits (1221-309 Thread Repair Kit - amazon.com CRC BRAKLEEN Brake Parts Cleaner - Non-Flammable -1lb 3 Oz (05089) $477. I pulled the inner pad out and squeezed the larger of the three clips to lessen the spring force and his helped considerably. DoItYourself.com, founded in 1995, is the leading independent Apr 23, 2016. It is much beter to strip a cheap ass bracket or caliper than your fork lowers. Take a look at the photos. To subscribe to this RSS feed, copy and paste this URL into your RSS reader. Copyright 2002-2021 Audi A2 Owners' Club (A2OC). Good luck! Cram a slightly larger bolt in there? I didn't torque it down; I just tightened it nice and snug. has motion/slop (do it up tighter, and use threadlocker to minimise vibration), bolt was cheap/underspecced and stretched during use/installation.